Difference between revisions of "XJTAG for new prototypes"

From ift
(Small list, hopefully helpful, made for the purpose of speeding up initial development for boundary scan testing.)
 
(No difference)

Latest revision as of 10:51, 20 May 2016

To make an automated test setup for a new prototype pcb, a few things are needed.

  • Cable from XJlink to fit the prototype board. From 2x10 pin ribbon cable connector to TAP connection on the PCB. Pins 1,2,4 & 20 are reserved for VCC, NC, GND & GND on the XJlink. The rest is configurable.
  • Netslist of the prototype circuit, for fast setup of XJDeveloper. This can be omitted, but having a netlist will make things faster and easier.
  • BSDL file for the JTAG equipped IC's on the pcb. This is needed to set up the JTAG chain for the XJDeveloper.
  • XJTAG also provides a .h file for interfacing drivers with C

links to api: XJAPI.h XJAPI docs