Cadence Virtuoso overview: Difference between revisions

From ift
No edit summary
 
(8 intermediate revisions by 4 users not shown)
Line 1: Line 1:
=Analog IC design flow using Cadence from basics (Schematic capture, Netlist extraction, Simulating using ELDO, Layout, Signoff Layout)=
= IC design flow using Cadence =


[[ TSMC 130nm process ]]
We have access to several silicon technologies from different foundries


[[ IHP 130nm process ]]
* 130nm CMOS process from Taiwan Semiconductor Manufacturing: '''[[ TSMC 130nm process ]]'''
* 130nm SiGe process from Innovations for High Performance Microelectronics: '''[[ IHP 130nm process ]]'''
* 350nm  CMOS process from Austria Mikro Systeme: '''[[ AMS 350nm process ]]'''


[[ AMS 350nm process ]]
= Design entry using schematic capture =
 
* Make sure you have set correct library.
* Make sure you run virtuoso from the same folder as your 'cds.lib'-folder ('~/LIBRARY_VENDOR/')
 
[[Design entry|Virtuoso schematic editor]]


= Simulation =
= Simulation =
Line 12: Line 19:


= Layout =
= Layout =
[[Get schematic ready for layout]]


[[Layout XL and IHP SG13S]]
[[Layout XL and IHP SG13S]]


=Helpful stuff=
=Helpful stuff=
[[MikroserverSetup]] - setup for easy connection to the mikroservers and Cadence Virtuoso


[[ Transistor operating point printer ]] - Script to extract transistor operating point parameters after simulation.
[[ Transistor operating point printer ]] - Script to extract transistor operating point parameters after simulation.


[[Category:Mikroelektronikk]]
[[DCoperatingparameters]] - Guide for showing transistor operating points in the schematic
 
[[ ADEXL-butterfly-curves ]] - Howto make DC butterfly curves easily.
 
[[Category:Mikroelektronikk]] [[Category:Integrated_Circuts]]

Latest revision as of 08:01, 6 September 2022

IC design flow using Cadence

We have access to several silicon technologies from different foundries

Design entry using schematic capture

  • Make sure you have set correct library.
  • Make sure you run virtuoso from the same folder as your 'cds.lib'-folder ('~/LIBRARY_VENDOR/')

Virtuoso schematic editor

Simulation

Virtuoso Testbench

Layout

Layout XL and IHP SG13S

Helpful stuff

MikroserverSetup - setup for easy connection to the mikroservers and Cadence Virtuoso

Transistor operating point printer - Script to extract transistor operating point parameters after simulation.

DCoperatingparameters - Guide for showing transistor operating points in the schematic

ADEXL-butterfly-curves - Howto make DC butterfly curves easily.