Busy Box and related: Difference between revisions

From ift
No edit summary
No edit summary
Line 14: Line 14:
=== Version history ===
=== Version history ===


'''1.0 (~april 2004)''' <br>
'''1.0 ''' <br>
<ul>
<ul>
<li> Made based upon TRD DCS FW version 011. </li>
<li> Magne Munkejord </li>
<li> Messagebuffer v1.0 (Torsten Alts orginal version)</li>
<li> Virtex driver for  programming RCU FPGA included </li>
</ul>
</ul>
<br>
<br>
'''1.01 (~may 2009)''' <br>
<ul>
<li> Added firmware register to 0x2015 </li>
<li> Updated Busy Controller module to handle orphan messages </li>
</ul>
<br>
=== Download Section ===
=== Download Section ===
[[Electronics_for_the_Time_Projection_Chamber_%28TPC%29#RCU_Trigger_Receiver_Module|RCU Trigger Receiver Module]]
[[Electronics_for_the_Time_Projection_Chamber_%28TPC%29#RCU_Trigger_Receiver_Module|RCU Trigger Receiver Module]]

Revision as of 11:15, 20 May 2009

Overview

Traditionally the Fee in ALICE sub-detectors indicates when its buffers are full and cannot handle further triggers from the CTP. This is either done directly or through the FANIN module to the LTU with a busy signal.

Due to dense cabling, four of the ALICE sub-detectors (TPC, PHOS, FMD and EMCal), utilize a BusyBox to keep track of free buffers in their Fec. The BusyBox asserts the busy signal to the LTU when one or more of these conditions are true:

  1. Buffers in Fec are full
  2. Upon receiving a trigger sequence from TTC
  3. When the TTC sends a global reset to the Fee

The busy signal is de-asserted when one or more FEC buffers are freed

The BusyBoxes are located in the DAQ counting rom.

Version history

1.0

  • Magne Munkejord


1.01 (~may 2009)

  • Added firmware register to 0x2015
  • Updated Busy Controller module to handle orphan messages


Download Section

RCU Trigger Receiver Module

Master Thesis, Magne Munkejord

PhD Thesis, Johan Alme

User Guide BusyBox, Rikard Bølgen